PureVPN goes :zap: hypersonic with latest 20Gbps server upgrades. Learn More

How to setup PureVPN on Netgear Genie (Having Genie Firmware only)

Download PDF

Now you can have your Netgear Genie working with PureVPN too. You can refer to the step-by-step guide below to manually setup PureVPN within minutes.

Things to Consider:

Before you begin, please make sure that:

  • You have a working internet connection
  • VPN Supported Router.
  • A Premium PureVPN account (If you haven’t bought yet click here to buy)
Find your VPN credentials for manual configuration.

  • Once logged in go to Account & Billing section.

  • On Account and Billing section click on drop-down icon

  • Click on Show/Update VPN password

  • Note down your PureVPN username and click on Eye icon to make your password visible and use it in the manual configuration.

How to connect PureVPN manually on Netgear Genie.
  • Access your router control panel and click VPN Client from left side panel.
    1. Place a check Enable VPN Client.
    2. Under VPN Server select PureVPN.
    3. Under VPN Protocol select any desired protocol.
    4. Under Country select any desired location of your choice.
    5. Enter your PureVPN credentials. Here is how you can find your VPN credentials.
    6. Click Connect

Netgear Genie VPN Setup

How helpful did you find this answer?

Comments (4 )

4 Comments

  1. Peter Reich says:

    I have a netgear Nighthawk R8500 Router and there i can not find this menu point. I have only the menu point VPN Service. But here i can not see how i can define the purevpn service.