With the high popularity in demand of NetDuma and Nighthawk recently and you prefer to connect on the internet, then here’s a guide for you to configure on NetDuma and Nighthawk routers.
Things to Consider:
Before you begin, please make sure that:
Configuring Netduma and Nighthawk
PureVPN is now added in below NetGear ( Netduma & Nighthawk ) through the Hybrid VPN option.
Hybrid VPN is available on the latest firmware for Netduma R1, Nighthawk XR500, XR450, and XR700**
For Netduma R1: if you are signed up to the Open Beta, you will receive an email from [email protected] with the latest firmware and instructions. Please go here if you have not signed up yet: https://netduma.com/r1-dumaos/
For Nighthawk: Upgrade to the latest XR500 firmware by going to >Settings >Administration >Firmware Update and then clicking Check. The latest firmware may have already been installed, but if not, confirm you would like to proceed with the upgrade.1 This image shows how your VPN setup will look like.
2 Click Hybrid VPN option and under Basic tab enter the following details.
Username: Your username provided by PureVPN
Password: Your password provided by PureVPN
( Important Note: Your email address is not your VPN login username. )
Country: Select the desired country.
Protocol: Select either TCP or UDP
3 In order to connect, click “Enable” and your logs will identify that you’re connected.
4 In order to redirect VPN traffic on specific devices, click “Add device” on the right side and you’ll see the list of devices connected to and the selection of your preferred device will be using VPN.
Comments (2 )